![]() You need to use a heat torch and not something like a hair dryer to do this, as the heat from a hair dryer isn’t direct enough and can cause your resin to move and also dirt to be blown into it. Gently use sweeping movements to hover over your work with the heat torch applying direct heat to pop the bubbles as you go.īe careful not to get the heat torch too close to your project, and don’t hold it on one area too long, this can cause other issues like rippling. ![]() If you pour in layers this air won’t get trapped at the bottom and will allow you to get rid of any surface bubbles that do appear each layer to be removed. If you pour a thicker project then air can get trapped under your project, creating bubbles at the bottom of your mold that you cannot remove while your resin is curing. The last thing you want is to do something that alleviates one issue, but causes another.Ĭraft Resin is a designed as a coating resin, one that you coat your artwork with, although it is great at other projects too, you need to create thicker projects in layers. Make sure the lids are kept on the bottles fully secured, make sure the water doesn’t go above the Craft Resin label, and dry the bottles off before opening and measuring.Īny moisture that gets into your resin will affect your project in other ways. You can warm your resin/hardener bottles in a warm sink of water for about 10-15 minutes before you then measure them out. These cannot be removed once your work has cured, so you need to adjust the temperature before you begin. ![]() The misty/milky look is due to lots of tiny micro-bubbles that form in cold resin. Between these temperatures your resin will be a joy to work with, it will flow really well and won’t have a misty look to it, it will be perfectly clear. The ideal temperature to work with and have your resin/hardener is between 21-24C or 70-75F. Resin loves warm temperatures and you need your work area and resin/hardener to be warm for your project to work really well. If your resin mix turns a misty/milky looking appearance to it then it means that you are having temperature issues and it is too cold. But if these pesky bubbles do pop up in your work and you want to get rid of them, then keep reading… The best way to stop bubbles from appearing in your work is to understand what causes them:Ĥ - Your project is releasing trapped airĭon’t worry, a lot of people, especially when they are new to resin art do have issues with bubbles at the beginning. Beauty is in the eye of the beholder, bubbles aren’t always bad. Some projects look great with bubbles in them, and some projects need bubbles for a certain look to be achieved. Unless you would like to create a project with bubbles in it, then please read this guidance and do the opposite! You can certainly achieve a clear, glass like finish to your epoxy resin projects and create work that doesn’t have bubbles in it. Craft Resin’s epoxy resin is bubble free when you follow the techniques that we are about to share with you.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |